Won't Drain
Water left sitting in the drum usually means a clogged pump filter, a coin or sock jammed in the drain pump, or a kinked drain hose.
Front-load & top-load washer repair · Bedford, NS
A washer that stops mid-cycle leaves you with a drum of soaking laundry and a growing pile in the hamper. Our licensed, insured technicians fix front-load, top-load and stacked machines from every major brand right in your laundry room, often the same day, with one agreed price and a 90-day parts and labour warranty.
If it's leaking: close the hot and cold taps behind the washer and unplug it before you mop up. Leave the load inside so the technician can see how far the cycle got.
Common Problems We Fix
Most washer breakdowns trace back to parts that wear a little with every load: drain pumps, belts, door seals, lid switches, shock absorbers and bearings. We keep the common ones on the van, so a stalled machine is usually running again before we pack up.
Water left sitting in the drum usually means a clogged pump filter, a coin or sock jammed in the drain pump, or a kinked drain hose.
Clothes come out dripping. A worn drive belt, a broken motor coupler, a faulty lid switch or an out-of-balance sensor can all stop the spin.
A puddle in front of a front-loader often means a torn door boot seal. Water underneath points to a cracked tub hose, a loose pump or a worn fill hose.
No lights, no fill, or just a click. We check the door lock, lid switch, control board and power supply to find where the start-up stops.
A washer that bangs or creeps across the floor on spin usually has worn shock absorbers, broken suspension springs or failing drum bearings.
A front-load door that stays locked after the cycle, or won't lock so the wash can begin, points to the door lock assembly or its latch.
Codes such as OE, 4C, F21 or UE each point to a specific system. We read them against the service data for your model instead of guessing.
Grinding on spin is a classic sign of worn tub bearings, while a squeal usually comes from a slipping belt or debris caught in the pump.
Problem not listed? Call (902) 901-5323 with the brand and what the washer is doing. We'll give you a straight idea of what the visit involves.
We repair all major washer brands:
Front-load, top-load and everything in between:
1visit
Drain pumps, belts, door boot seals, lid switches and shock absorbers ride in our vans, so the majority of washer repairs are finished the first time we come out.
Call in the morning and a technician can usually be in your laundry room that same day, weekends included.
We find the fault, then quote parts and labour together. No repair begins until you give the go-ahead.
The parts we fit and the work we do are covered for 90 days. If the same problem comes back, we return at no charge.
Licensed, insured technicians who work safely around water, power and a machine that can weigh over 90 kg.
If a cracked outer tub or failed transmission makes a repair poor value, we tell you before you spend anything.
Call or send the form with the brand and what the machine is doing. We book a time, often for the same day.
The technician runs a test cycle, reads any error code and gives you the full repair price before starting.
Once the part is replaced we run the washer to confirm it fills, drains and spins, and the repair is covered for 90 days.
We keep our work inside Bedford, so whether your laundry room is in a Paper Mill Lake townhouse or a condo off Larry Uteck Boulevard, a technician is a short drive away. Less time on the road means more same-day openings for you.
Don't see your area? Every Bedford address is covered. Call (902) 901-5323 and we'll book you in.
The most common cause is a blocked drain pump or pump filter, often from a sock, coin or hair tie. A kinked drain hose or a failed pump motor are the next suspects, and if your model has a small access panel at the bottom front, clearing that filter yourself is worth a try first.
Detergent residue and moisture trapped in the door boot seal and drain system feed mould and mildew. Wipe the seal after washing, leave the door open to dry, and run a hot cleaning cycle monthly; if the smell stays, a partly blocked drain may be the cause and worth a service call.
In most cases, yes: same-day washer appointments run seven days a week from 7 AM to 11 PM, and pumps, belts and seals are stocked on the van. When a part has to come from a supplier, you'll know the wait up front.
Yes, if the machine is under about 10 years old and the fault is a pump, belt, switch, seal or shock absorber. Failed drum bearings or a cracked outer tub on an older washer can cost close to a new machine, and we'll say so honestly when that's the case.
Yes, we repair stacked laundry centres, compact and apartment-size washers, and full-size front-load and top-load machines from all major brands.
Phone for the fastest same-day booking, or leave your details and we'll call you to arrange a time.
Open 7 days · 7 AM–11 PM
What happens next
Request a Callback
We'll call to schedule your washer repair.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thanks, request received.
We'll call you shortly to book the washer repair. Water on the floor? Call (902) 901-5323.